The inner diameter of the drive shaft nut should ensure an effective interference fit with the shaft. The standard recommends selecting a nut 0.1-0.3 mm larger than the shaft diameter. For heavy-duty applications, finite element analysis is required to verify the contact stress distribution.
According to ISO 898-1, axial working load, radial impact load, and preload attenuation coefficient must be comprehensively calculated. It is recommended to use the torque-angle method to control the installation preload, ensuring it reaches 70%-90% of the bolt yield strength.
High-strength alloy steel (e.g., 42CrMo4) nuts are suitable for temperatures below 400℃. For high-temperature environments, A286 stainless steel should be used. Dacromet surface treatment is recommended, and a salt spray test exceeding 1000 hours is required.
Metric thread marking example: M12×1.75-6H, where 1.75 represents the pitch and 6H is the internal thread tolerance zone. For US standard UNF fine thread, the number of threads per inch must be specified separately (e.g., 1/2-20 UNF).

